We’ve been making steady progress behind the scenes on the 1:24 scale die-cast Cat® 395 Excavators, and while it’s still too early to reveal everything, we wanted to share a few updated screenshots from the tooling process.
These images offer a small glimpse into the incredible detail and engineering that goes into bringing a new CCM model to life. As many collectors know, the journey from concept to finished replica is a long one, and seeing the tooling evolve is one of many stages along the way.
Looking good! Are you planning on making different variations? It looked like the prototype was a mass excavator set up. I run a 390F for the mines in Safford. It weighs in at about 190k lbs. The 395’s weigh in at about 210k pounds. Quite a bit heavier.
Any idea on delivery date ?
Please some wiring inside the engine and the side service areas perforated.